Axial piston fixed displacement pumps

High-pressure pump for use in commercial vehicles, in inclined axle design, open circuit.
Flange and shaft for direct mounting on the power take-off of commercial vehicles, weight optimised by aluminium die-cast housing. Connecting flange 80 x 80 mm, 4 – hole, centering diameter 80mm. Splined shaft 8x32x35 (similar to DIN ISO 14)

• No leakage line required
• Low operating noise
• Easy adaptation to drive direction
• Good suction behaviour
• High overall efficiency
• Long service life

The A17FO constant pump is designed for use with mineral oil HLP in accordance with DIN 51524, purity class 19//17/14 in accordance with ISO 4406.
10 bar minimum pressure on the high pressure side (A) required to prevent damage to the axial piston unit.
The pressure nozzle is pre-assembled at delivery and must be tightened with the torque specified for the corresponding thread size before installation!
The direction of rotation of the axial piston unit is determined by a pressure nozzle screwed into the working connection and can be easily changed. The direction of rotation in the as-delivered state is anticlockwise, looking at the shaft.

When installing the pump, it is essential to observe the operating instructions!