Bosch/Rexroth Axial piston fixed displacement pump
Part no.: 256R902162396
Further information
- Displacement (cc/rev):
- 80,4
- Volume flow max. (l/min):
- 172.86
- Operating pressure max. (bar):
- 350
- Max. speed (1/min.):
- 2150
- Drive shaft:
- Splined shaft 8x32x35
- Power consumption max. (kW):
- 101
- Direction of rotation:
- Anticlockwise
- Pump type:
- A17-FO
- Inlet connection:
- G 1.1/4" (BSP)
- Outlet connection:
- G 1" (BSP)
- Version:
- Einkreispumpe
- Adaptor plate hole pattern (mm):
- 80x80 (4-Loch)
- Fitting Ø (mm):
- 80
- Type:
- Konstantpumpe
- Additional information:
- zur Änderung der Drehrichtung muss nur die Reduzierverschraubung für den Druckstutzen gewechselt werden
- Weight:
- 13,15 kg
- Catalogue:
- Hydraulics & pneumatics (p. 929)
High-pressure pump for use in commercial vehicles, in inclined axle design, open circuit.
Flange and shaft for direct mounting on the power take-off of commercial vehicles, weight optimised by aluminium die-cast housing. Connecting flange 80 x 80 mm, 4 – hole, centering diameter 80mm. Splined shaft 8x32x35 (similar to DIN ISO 14)
• No leakage line required
• Low operating noise
• Easy adaptation to drive direction
• Good suction behaviour
• High overall efficiency
• Long service life
The A17FO constant pump is designed for use with mineral oil HLP in accordance with DIN 51524, purity class 19//17/14 in accordance with ISO 4406.
10 bar minimum pressure on the high pressure side (A) required to prevent damage to the axial piston unit.
The pressure nozzle is pre-assembled at delivery and must be tightened with the torque specified for the corresponding thread size before installation!
The direction of rotation of the axial piston unit is determined by a pressure nozzle screwed into the working connection and can be easily changed. The direction of rotation in the as-delivered state is anticlockwise, looking at the shaft.
When installing the pump, it is essential to observe the operating instructions!
Flange and shaft for direct mounting on the power take-off of commercial vehicles, weight optimised by aluminium die-cast housing. Connecting flange 80 x 80 mm, 4 – hole, centering diameter 80mm. Splined shaft 8x32x35 (similar to DIN ISO 14)
• No leakage line required
• Low operating noise
• Easy adaptation to drive direction
• Good suction behaviour
• High overall efficiency
• Long service life
The A17FO constant pump is designed for use with mineral oil HLP in accordance with DIN 51524, purity class 19//17/14 in accordance with ISO 4406.
10 bar minimum pressure on the high pressure side (A) required to prevent damage to the axial piston unit.
The pressure nozzle is pre-assembled at delivery and must be tightened with the torque specified for the corresponding thread size before installation!
The direction of rotation of the axial piston unit is determined by a pressure nozzle screwed into the working connection and can be easily changed. The direction of rotation in the as-delivered state is anticlockwise, looking at the shaft.
When installing the pump, it is essential to observe the operating instructions!